Web To Bungee Buckle - As Used
Web to Bungee Assemble
This two-part piece rarely breaks. We sell this part in sets, the barrel & the web buckle. This part is used on the following bags:
Mountain Wedge III
Mountain Handle Pack II
To assemble this unit:
1) Slide Barrel onto Bungee
2) Twist Bungee (1/4" or 6mm) through Web loop, so that the bungee comes through the tunnel hole at least 1/8" or more. (I.e. it should be sticking out the end with the screw hole.
3) Pull the barrel down over the web loop causing the teeth to engage. You will need a pair of pliers to do this step.
To disassemble this unit:
1) Take a flat head screwdriver and wedge it between the barrel and the web loop. Once wedged in twist the screwdriver causing further separation.
2)Pull the barrel off and twist the bungee out.
NOTE: It is important to know how to do this so you can adjust your bungee if it is too loose. You can always take up some slack if you understand these instructions.
FANNY PACKS & HYDRATION SYSTEMS
BACKPACKING & ACCESSORIES
BOOK PACKS SHOULDER PACKS
TRAVEL PACKS LUGGAGE & ACCESSORIES
POLICE & FIREFIGHTER
© 2018 Jandd Mountaineering, Inc.