Click Images Below to View Larger
Expedition Rear Rack
The Expedition Rack is the rack of choice for cyclists who require exceptional durability and expanded size, measuring a full three inches longer than our standard rack. Built from 3/8" 6061 aluminum stock, the Expedition Rack is intended to be used primarily with our Large Mountain and Expedition Panniers where additional rear clearance may be needed for large loads. However, the Expedition is also a good choice when more room is needed for carting the evenings firewood or portaging large containers of water. The secret to this racks tremendous strength is a third support strut which angles back 21 degrees from the main load bearing strut. In addition, the rear support strut offers a 6" long section for attaching the lower portion of your panniers suspension system to enable precise positioning of your load. All stress points are double-welded.
Mounting Instructions For Rear Rack
Weight: 36 oz/1 kg
Length: 16.75in/43 cm
Height: (Overall) 15 in/38 cm
Height: Pannier Mounting 12 in/30.5 cm
Width: 6 in/15.25 cm
WEIGHT CAPACITY 75 LBS
FAQ: Will this rack fit my wheel?. The total length from the bottom mount point to the bottom of the plate is 13.75 inches. Measure from your bikes bottom attachment to the top side of the tire, if this is less than 13.75 it should work. You must measure to the top of your tire as the bottom attachment point on the bikes vary, so if this point is higher than you hub you might only need a regular size rack even on a larger wheels. If you are close or the distance is greater review the
Expedition Tall Boy model.
Field Note: 2003 Expedition Racks (built after June 2002) are much stiffer at the base. We now have two 3/8 inch rods welded together at the maximum stress point.
Unpainted Silver Aluminum - Allow 3-4 Weeks
FANNY PACKS & HYDRATION SYSTEMS
BACKPACKING & ACCESSORIES
BOOK PACKS SHOULDER PACKS
TRAVEL PACKS LUGGAGE & ACCESSORIES
POLICE & FIREFIGHTER
© 2019 Jandd Mountaineering, Inc.